IndraDrive MPx-16 to MPx-19 / PSB fault codes & diagnostics

Loss of measuring encoder reference

Modulo limitation error of motor encoder

Modulo limitation error of optional encoder

Modulo limitation error of measuring encoder

Incorrect Ethernet configuration

Analog input, wire break

Error in mains synchronization

Undervoltage in mains

Overvoltage in mains

Softstart fault power supply unit

Phase failure

Mains failure

Braking resistor overload

Error in control of braking resistor

Switch-on threshold braking resistor too low

Ground fault in motor line

Contactor control error

DC bus balancing monitor error

Overcurrent in mains-side power section

Overvoltage in power section

Undervoltage in power section

STO/SBC while drive enabled

Overcurrent in power section

Positive position limit exceeded

Negative position limit exceeded

Emergency-Stop activated

Torque/force actual value limit active

Current limit active

Both travel range limit switches activated

Positive travel range limit switch activated

Negative travel range limit switch activated

Motor overload, current limit active

Device overload, current limit active

Drive system not ready for operation

Torque/force command value limit active

SMO: Error within the safety zone

Error in processing of diagnostic message

Mains failure

Sync telegram failure

RTD telegram failure

No command value input via master communication

Communication module overload

sercos: Consumer connection failed

Invalid addressing command value data container A

Invalid addressing actual value data container A

Slave not scanned or address 0

Communication watchdog: Overload of cyclic communication

Maximum number of CCD slaves exceeded

Incorrect CCD addressing

Incorrect phase switch of CCD slaves

CCD: Topology error

CCD: Unknown I/O configuration

sercos: Ring interruption (FF to LF)

Prewarning, end of brake check time interval

One-time telegram failure, power section parallel bus

Position control with encoder 2 not possible

PLC - Warning no. 1

PLC - Warning no. 2

PLC - Warning no. 3

PLC - Warning no. 4

PLC - Warning no. 5

PLC - Warning no. 6

PLC - Warning no. 7

Differing DC bus voltages with parallel connection

Motor temperature outside of measuring range

Collective warning of power section

Current unbalance in parallel connection

Device blower defective

Undervoltage in power section

Encoder 1 warning: Signal amplitude incorrect

Excessive position command difference warning

Device overtemperature 2 prewarning

Encoder 2 warning: Encoder signals incorrect

Measuring encoder warning: Encoder signals incorrect

Positioning velocity >= limit value

Device overtemp. prewarning

Motor overtemp. prewarning

Target position out of travel range

Not homed

Feedrate override S-0-0108 = 0