ECODRIVE03 SGP03VRS fault codes & diagnostics

Cam shaft invalid

Switching to uninitialized operation mode

UL The motor type has changed.

PL Load parameter default values

Blower not connected

Amplifier overtemperature shutdown

Motor overtemperature shutdown

Braking resistor overload shutdown

Motor temp. surveillance defective

Error during initialisation of the parking axis

Maximum braking time exceeded

Undervoltage in power section

Excessive deviation

Encoder 1 failure: quadrant error

Max. signal frequenc y of encoder 1 exceeded

Excessive position feedback difference

Excessive position command difference

Encoder 2 failure: signal amplitude wrong

Encoder 2 failure: quadrant error

Max signal frequenc y of encoder 2 exceeded

Low battery voltage

Master drive encoder failure: signal too small

Overflow of target position preset memory

Master drive encoder failure: quadrant error

Incr. encoder emulator: pulse frequenc y too high

Command current limit shutoff

External short at status outputs

Erroneous internal hardware synchronization

Error during release of the motor holding brake

Absolute encoder out of allowed window

Current measurement trim wrong

Mains fault

No ready signal from supply module

Double MST failure shutdown

Double MDT failure shutdown

Invalid communication phase shutdown

Error during phase progression

Error during phase regression

Phase switching without ready signal

Error during initialization of master communication

Fatal error of the interface card

Emergency-Stop

Positive travel limit exceeded

Negative travel limit exceeded

Emergency-Stop

Positive travel limit switch detected

Negative travel limit switch detected

Commutation offset could not be determined

Motion range exceeded during commutation

Encoder 1 failure: signal amplitude wrong

Safe Halt while drive activated

Encoder 2 failure: signal amplitude wrong

Encoder 2 failure: quadrant error

Overcurrent: short in power stage

+24Volt DC error

Power supply driver stages fault

Velocity loop error

Velocity limit S-0-0091 exceeded

Cooling fan too slow

W arning Motor temp. surveillance defective

Motor overload

Undervoltage in power section

Interpolation velocity = 0

Interpolation acceleration = 0

Positioning velocity >= S-0-0091

Drive overtemp. prewarning

Motor overtemp. prewarning

Braking resistor overload prewarning

Target position out of travel range

Not homed

Feedrate-override S-0-0108 = 0

Torque limit = 0

Continuous current limit active

Selected process block is not programmed.

Command velocity limit active

Command Current limit active

Continuous current limit pre-warning

Velocity command value > limit S-0-0091

Target position out of num. range

Brake torque too low