DKC01.1 / DKC11.1 ECODRIVE ASE02VRS fault codes & diagnostics

Switching to an Uninitilized Operating Mode

Heatsink Overtemperature Shutdown

Motor Overtemperature Shutdown

Bleeder Overtemperature Shut Down

Undervoltage Error

Excessive Deviation

Motor Encoder Error: Quadrant Error

Low Battery Voltage

Status Outputs Short Circuited

Absolute Encoder Error, Position Deviation > P-0-0097

Travel Limit Value Exceeded

Travel Limit Switch Detected

Motor Encoder Failure: Signal too Small

Overcurrent: Short in Powerstage

+24 V Error

Power Supply Driver Stage Fault

Velocity Loop Error

Velocity Limit Value Exceeded (S-0-0092)

4 kHz Signal Error

Heatsink Overtemperature Warning

Motor Overtemperature Warning

Bleeder Overtemperature Warning

Target Position Out of Range

Drive not Referenced

Feedrate-Override(S-0-0108) = 0

Torque Limit Value = 0

Continuous Current Limiting Active

Selected Process Block is not Programmed

Command Velocity Limit Active

Target Position not Representable

Overvoltage Warning

Position Limit Value Exceeded

Position Limit Value Reached During Jogging

Travel Limit Switch Activated

Communication Phase 3 Transition Check

Invalid Communication Parameters (S-0-0021)

Limit Error Communication Parameters (S-0-0021)

Communication Phase 4 Transition Check

Invalid Parameter Block (-> S-0-0022)

Limit Error Parameter (-> S-0-0022)

Parameter Calculation Error (-> S-0-0022)

Loading Error LCA

Invalid SSI Parameter (-> S-0-0022)

Invalid Feedback Data (-> S-0-0022)

Invalid Amplifier Data (-> S-0-0022)

Position Data Scaling Error

Velocity Data Scaling Error

Acceleration Data Scaling Error

Torque Data Scaling Error

Motor Feedback Data Reading Error

Motor Feedback Initilization Error

Modulo Range Error

Command: Set Emulation - Absolute Value

Set Absolute Measuring

Setting Absolute Measurement not Allowed, Drive Enabled

Absolute Measurement System not Installed

Switch from Operational to Parameter Mode

Active Drive, Transition is not Permissable

Reset Class 1 Diagnostic

Drive Controlled Homing Procedure

Homing Procedure not Possible without Drive Enable

Zero Switch to Home Reference Error

Homing Procedure not Possible in this Operating Mode

Homing Procedure not Possible with Absolute Measurement Control

Basic Load

Load Basic Parameters

Communication Phase 2

Communication Phase 3

Drive Halt

Control and Power Sections Ready for Operation

Ready for Power

Drive in Torque Mode

Drive in Velocity Mode

Position Control/Stepper Drive Interface

Position Regulation without Lag/Stepper Drive Interface

Position Regulation/Positioning Drive

Position Regulation without Lag/Positioning Interface

Motor Type not Reported

Default Value of the Parameter Load

Drive Enable