IndraMotion MLC 04VRS fault codes & diagnostics

Resulting path velocity too high

Resulting path velocity too high

Resulting path velocity too high

Resulting path velocity too high

Resulting path velocity too high

Resulting path velocity too high

No name specified with call of SET_RK_SYSTEM

RCL-Compiler: Character not read

RCL-Compiler: Symbols will be ignored up to end of file

RCL-Compiler: Symbols up to end of file will be ignored

RCL-Compiler: Only EXTERN and GLOBAL permitted

RCL-Compiler: No defined variable as type BINARY declared

RCL-Compiler: No defined variable as type CHAR declared

RCL-Compiler: Implicit point definition

RCL-Compiler: Illegal alignment

Size of parameter changed

Parameter write-error during import, see C-0-0114

Import/Export: file could not be opened

Import/Export: unknown parameter type

Import: length of line in import file exceeded maximum

Import/Export: unsupported SERCOS parameter format

SERCOS bus not closed

Progression to phase 3 not possible

Progression to state ready not possible

Drive not found

Maximum number of drives exceeded

MC cycletime too less

Parameter write protected by password

RTOS error (Real Time Operating System)

Cannot write on parameter S-0-0015

Cannot write on parameter S-0-0016

Cannot write on parameter S-0-0024

Cannot write on parameter S-0-0007

Cannot read time slot parameter

Cannot read time slot parameter

Cannot write on time slot parameter

Cannot write on time slot parameter

Command already set

Error while setting module references

Error in power up delay

Error while switching to power up target mode

Error remanent data; data cleared

Error remanent data; restored last backup

Output shorted

Voltage supply dropped

Watchdog error

Module removed

Fault repaired

Multiple error, fast IOs

Cyclic position channel already open

Cyclic force channel already open

Cyclic velocity channel already open

Cyclic analog channel already open

Error while reading C-0-0483

Error while reading C-0-0484

Error while opening cyclic channel

Error while opening cyclic channel

No reference for opening cyclic channel available

Wrong #-address of axis data

Wrong #-address of axis data

Wrong #-address of axis data

Error while closing cyclic channel

Error closing cyclic channel

ListParameter requested, ReadParameter

Error closing cyclic channel

Invalid control number

Invalid axis number

Error, cannot handle a single parameter

Error, data greater 64KBytes

Error, cannot handle a single parameter

Error ReadSERCOSDataStatus, no memory available

Error, no memory available

Error, cannot handle a single parameter

Too many data to transmit

Error, no memory available

Error, cannot handle a single parameter

Error writing date

Error ReadSERCOSAttribute, no memory available

Access error, axis 1

Access error, axis 2