IndraMotion MLC 04VRS fault codes & diagnostics

Division (16bit) by zero - Divisor modified to 1!

Division (32bit) by zero - Divisor modified to 1!

Division (REAL) by zero - Divisor modified to 1.0!

Lower range bounds (unsigned) violation - Value to MIN!

Upper range bounds (unsigned) violation - Value to MAX!

Lower range bounds (signed) violation - Value to MIN!

Upper range bounds (signed) violation - Value to MAX!

Division (LREAL) by zero - Divisor modified to 1.0!

Invalid pointer access (address) - Pointer to a dummy!

Invalid pointer access (area) - Pointer to a dummy!

Invalid pointer access (Write on input)- Pointer to a dummy!

Invalid pointer access (alignment) - Pointer to a dummy!

WriteParameter, inputs do not fit to attribute of parameter

WriteParameter, inputs do not fit to attribute of parameter

WriteParameter, inputs do not fit to attribute of parameter

WriteParameter, inputs do not fit to attribute of parameter

WriteParameter, parameter types are not supported

Module error Inline bus goes

No entry found in data base

OK

P0 STOP, reached phase 0, PLC in stop

P1 STOP, reached phase 1, PLC in stop

P2 STOP, reached phase 2, PLC in stop

P3 STOP, reached phase 3, PLC in stop

BB STOP, Motion ready, PLC in stop

P0 RUN, reached phase 0, PLC in run

P1 RUN, reached phase 1, PLC in run

P2 RUN, reached phase 2, PLC in run

P3 RUN, reached phase 3, PLC in run

BB RUN, Motion ready, PLC in run

P0 INIT, reached phase 0, PLC in init

P1 INIT, reached phase 1, PLC in init

P2 INIT, reached phase 2, PLC in init

P3 INIT, reached phase 3, PLC in init

BB INIT, Motion ready, PLC in init

Firmware download successfully finished

Hardware changed; Restoring NVRAM

Restoring NVRAM

New power up

Kinematics has been removed

Kinematics has been created

ASIC Error

Drive warning

Parameter inconsistent, restorage via C-0-1001

Running on unsupported hardware

Running on unsupported hardware revision

Writeaccess to parameter S-0-0000 of UserCmdDataX

Unknown PLC system task

Nonconforming Inline IO Configuration

Version conflict in error logbook, logbook deleted!

Axis in 'PowerOn'

Axis not in 'StandStill'

Positive travel limit exceeded

Negative travel limit exceeded

Axis position is extrapolated

Maximum acceleration exceeded

Velocity of interpolation = 0

Acceleration of interpolation = 0

Positioning velocity greater than Limit (A-0-0032/ 33)

Feedrate Override A-0-0240=0

Commanded velocity greater than Limit (A-0-0032/ 33)

Configured master axis is parking

Warning: Motion kernel exceeded control cycle time

Usable memory (RAM) near minimum

Usable memory (CF) near minimum

Temperature warning

CPU-Load critical

Usable memory (USR) near minimum

Usable memory (SYS) near minimum

Usable memory (OEM) near minimum

Battery of SRAM module low

Error in SYS-partition, check done

Error in OEM-partition, check done

Error in USR-partition, check done

Velocity of the axis too high

Velocity of the axis too high

Vector assignment with different components

SRAM batterie low

Axis deactivated

Resulting path velocity too high