IndraDrive MPx-02 to MPx-08 / HMV fault codes & diagnostics

Brake error

Error when releasing the motor holding brake

Actual pos. value 1 outside absolute encoder window

Actual pos. value 2 outside absolute encoder window

Actual pos. value 3 outside absolute encoder window

Current measurement trim wrong

Error supply module

Module group communication error

Incorrect access to command value memory

It was impossible to address MMC

It was impossible to address I2C memory

It was impossible to address EnDat memory

Commutation offset invalid

It was impossible to address Hiperface memory

Error in non-cyclical data communic. of power section

MMC: Defective or missing, replace

MMC: Incorrect data or file, create correctly

MMC: Incorrect IBF file, correct it

Retain data backup impossible

MMC: Saving too slowly, replace

Error comfort control panel

CCD slave error

MLD motion function block error

Loss of motor encoder reference

Loss of optional encoder reference

Loss of measuring encoder reference

Modulo limitation error of motor encoder

Modulo limitation error of optional encoder

Modulo limitation error of measuring encoder

Incorrect Ethernet configuration

Command current limit shutoff

Analog input 1 or 2, wire break

PLL is not synchronized

Undervoltage in mains

Overvoltage in mains

Softstart fault power supply unit

Overvoltage in power section

Phase failure

Mains failure

Braking resistor overload

Error in control of braking resistor

Switch-on threshold braking resistor too low

Ground fault in motor line

Contactor control error

Mains contactor wiring error

DC bus balancing monitor error

Contactor monitoring error

Error supply shutdown

Overcurrent in mains-side power section

Invalid device code

Incorrect interrupt timing

Hardware variant not supported

Overvoltage in power section

Undervoltage in power section

Safe torque off while drive enabled

Overcurrent in power section

Positive position limit exceeded

Negative position limit exceeded

Emergency-Stop activated

Torque/force actual value limit active

Current limit active

Both travel range limit switches activated

Positive travel range limit switch activated

Negative travel range limit switch activated

Motor overload, current limit active

Device overload, current limit active

Drive system not ready for operation

Torque/force command value limit active

PLL is not synchronized

Undervoltage in mains

Overvoltage in mains

Phase failure

Mains failure

Double MST failure shutdown

Double MDT failure shutdown

No command value input via master communication

Communication module overload

SERCOS III: Consumer connection failed

Invalid addressing command value data container A

Invalid addressing actual value data container A