IndraMotion MLC 04VRS fault codes & diagnostics

MaxNumberOfMarkerFailure is not in valid range

Interpolation is not in valid range

TimeStampEnable is not in valid range

DeadTimePosEdge is not in valid range

DeadTimeNegEdge is not in valid range

ProbeData is not in valid range

PositionEvalMode is not in valid range

DiffEvalMode is not in valid range

TOUCHPROBE_REF is not valid or wrong configuration

AXIS_REF is not valid or wrong configuration of axis

Path / file name unknown

Unsupported file system

Input 'StartIdx' has an invalid value

Invalid state of state machine

Error in file structure

Input 'ArrayDimension' has an invalid value

Point not found

Wrong number of coordinates per point

Wrong number of kinematics

Wrong point type, point in world or joint coordinates

MC_DigitalCamSwitch, Unable to acquire APS reference

MC_DigitalCamSwitch, Unable to open cyclic channel

MC_DigitalCamSwitch, Unable to allocate memory

MC_DigitalCamSwitch, Unable to read parameter

MC_DigitalCamSwitch, Invalid combination of units

MC_DigitalCamSwitch, On-/Off compensation time longer 16sec

MC_DigitalCamSwitch, Invalid state of state machine

ML_PIDType01, Low limit is higher than High limit

ML_PIDType01, Invalid state of state machine

ML_PIDType01, Selected controller type not supported

Inputs have invalid values

Invalid state of state machine

Calculations resulted in invalid values

Reference to base system was not found

Function block could not be instatiated

Function block may not be located in RETAIN data area

Link ring broken

Link ring - masterposition incorrect MDT

Link ring - masterposition incorrect AT

C2C XML File not available

C2C XML File format error

C2C XML File format invalid

C2C XML File Unknown parser error

C2C Ring not closed

C2C Conciguration not consistent

C2C Error switching phase 1

C2C Error device not found

C2C Error switching phase 2

C2C Error switching phase 3

C2C Error command S-0-0127, P3 transition check

C2C Error switching phase 4

C2C Error command S-0-0128, P4 transition check

C2C Connection not found

C2C Wrong ring address

C2C Error phase chance start Phase 3

C2C Error phase chance start Phase 4

C2C Ring Configuration ID not constant

C2C Version not constant

C2C Wrong ring delay

C2C Wrong Synchronization delay

C2C SERCOS Cycle time not possible

C2C Offset AT invalid

C2C Unknown producer data

C2C Unable to produce data

C2C Unable to consume data

C2C Producer cycle time not supported

C2C Producer cycle time less than SERCOS cycle time

C2C Producer cycle time no multiple of SERCOS cycle time

C2C Connection names not unique

C2C Maximal number of connections exceeded

C2C Configuration information incomplete

C2C Invalid ring configuration ID

C2C Cannot operate as master

C2C Cannot operate as slave

C2C Consumer data field length not corresponding

C2C Further master on port 1 detected

C2C Further master on port 2 detected

C2C Error switching phase 0

General kinematics error

Invalid control number