IndraMotion MLC 02VRS fault codes & diagnostics

Division (REAL) by zero - Divisor modified to 1.0!

Lower range bounds (unsigned) violation - Value to MIN!

Upper range bounds (unsigned) violation - Value to MAX!

Lower range bounds (signed) violation - Value to MIN!

Upper range bounds (signed) violation - Value to MAX!

Division (LREAL) by zero - Divisor modified to 1.0!

Invalid pointer access (address) - Pointer to a dummy!

Invalid pointer access (area) - Pointer to a dummy!

Invalid pointer access (W rite on input)- Pointer to a dumm y!

Invalid pointer access (alignment) - Pointer to a dumm y!

W riteParameter, inputs do not fit to attribute of parameter

W riteParameter, inputs do not fit to attribute of parameter

W riteParameter, inputs do not fit to attribute of parameter

W riteParameter, inputs do not fit to attribute of parameter

W riteParameter, parameter types are not supported

Nonconforming Inline IO Configuration

No entry found in data base

OK

P0 STOP, reached phase 0, PLC in stop

P1 STOP, reached phase 1, PLC in stop

P2 STOP, reached phase 2, PLC in stop

P3 STOP, reached phase 3, PLC in stop

BB STOP, Motion ready, PLC in stop

P0 RUN, reached phase 0, PLC in run

P1 RUN, reached phase 1, PLC in run

P2 RUN, reached phase 2, PLC in run

P3 RUN, reached phase 3, PLC in run

BB RUN, Motion ready, PLC in run

P0 INIT, reached phase 0, PLC in init

P1 INIT, reached phase 1, PLC in init

P2 INIT, reached phase 2, PLC in init

P3 INIT, reached phase 3, PLC in init

BB INIT, Motion ready, PLC in init

Firmware download successfully finished

Hardware changed; Restoring nvRAM

Restoring nvRAM

Drive warning

Parameter inconsistent, restorage via C-0-1001

running on unsupported hardware

W riteaccess to parameter S-0-0000 of UserCmdDataX

Version conflict in error logbook, logbook deleted!

Axis in 'PowerOn'

Axis not in 'StandStill'

Positive travel limit exceeded

Negative travel limit exceeded

Axis position is extrapolated

Maximum acceleration exceeded

Velocity of interpolation = 0

Acceleration of interpolation = 0

Positioning velocity greater than (A-0-0032/ 33)

Commanded velocity greater than Limit (A-0-0032/ 33)

Configured master axis is parking

Usable memory (RAM) near minimum

Usable memory (CF) near minimum

Temperature warning

CPU-Load critical

Size of parameter changed

Parameter write-error during import, see C-0-0114

Import/Export: file could not be opened

Import/Export: unknown parameter type

Import: length of line in import file exceeded maximum

Import/Export: unsupported Sercos parameter format

Fiber optic ring not closed

Drive error

Progression to phase 3 not possible

Progression to state ready not possible

Drive not found

Maximum number of drives exceeded

MC c ycletime too less

Parameter write protected by password

RTOS error (Real Time Operating System)

Cannot write on parameter S-0-0015

Cannot write on parameter S-0-0016

Cannot write on parameter S-0-0024

Cannot write on parameter S-0-0007

Cannot read time slot parameter

Cannot read time slot parameter

Cannot write on time slot parameter

Cannot write on time slot parameter

Command already set